Construction method of tactile paving water printing
In the initial setting stage of concrete, the product material powder is spread, and through necessary processes, the effective substances (including special cement additives) in this product penetrate into the concrete layer (with a larger penetration force of 10cm), and after bonding with the concrete, its bearing pressure increases by 1. Approximately 5 times thicker, and at the same time, a strong protective layer (about 3mm thick) is polymerized on the surface of the concrete.
Engineering practice has proven that in the formwork of the press mold floor, a certain pattern and pattern of lining board are arranged according to the design. After the concrete hardens and the formwork is removed, a three-dimensional decorative pattern can be formed on the surface of the press mold floor. This is a relatively simple and effective decoration method.
Features of tactile paving Water Printing Products
1. The compressive strength can generally reach three times that of ordinary concrete, and it has good impermeability;
2. Improve wear resistance and thoroughly prevent dust;
3. Using inorganic pigments, the color is firm and long-lasting, and it has good UV resistance;
4. Enhance friction coefficient - bright but not slippery;
5. Oil proof, waterproof, anti slip, the surface will not crack, peel off, or fade;
6. Beautiful and elegant in appearance, environmentally friendly, and widely used.