Construction steps for road embossing

       1. Repair the roadbed by grinding it flat, pouring concrete to the required height in low-lying areas, and grinding it flat to the required height in raised areas;

       2. The base concrete layer is covered with concrete on the ground roadbed;

        3. The reinforcement layer is sprayed with colored reinforcement material on the concrete layer. After the colored reinforcement material is moistened, the surface sprayed with colored reinforcement material is smoothed with an iron trowel. The colored reinforcement material is sprayed again on the concrete layer in a direction perpendicular to the previous direction. After the colored reinforcement material is moistened, the surface sprayed with colored reinforcement material is smoothed with an iron trowel;

        4. Sprinkle colored adhesive powder on the surface of the solidified colored ground reinforcement material in the molding layer;

        5. The compression mold is used to lay the required pattern templates on the compression layer, and a compactor is used to compact the templates. The patterns on the templates are transferred to the overlying compression layer, and then the two templates are pressed against the previous template to process the compression layer until the texture of the entire compression layer surface is embossed; Six steps: Clean the surface texture of the pressed mold layer after 72 hours of imprinting, and clean the remaining colored adhesive powder;